Hpvm backup windows guest

I have bookmark this page for my future reference. Home About Contact. This is installed on servers which do not support vPar or nPar. Resources such as processors, memory disk devices can be assigned from the VM Host and can be modified later at any point of time.

Modifying of resources such as cpu, memory as of now in version 3 is not dynamic and requires a reboot of the VM Guest. Dynamic assigning will be possible after release of version 3. Pre-Requisites to Installation:. Install the OS on the physical server where the virtual servers will be installed. The physical server on which the virtual servers will reside is called VM Host and virtual servers called as VM Guests. Installation Procedure:. Create a virtual network switch.

Stop and start the vm by:. Check the config for virtual switch. It should be a technical equivalent of the HP Virtual Machine 3. The boot disk of the initial virtual machine can be cloned with the Dynamic Root Disk to obtain a new virtual machine following these steps:.

Check that the new version is correctly installed. The clone target is specified on the drd clone command as a block device special file. To determine the device special files for both, the boot disk and the newly added disk, issue this command:.

To be sure which of these disks is the boot disk, locate the device special file in the output of the following command:.

Removing the hostname in the netconf file of the clone disk will cause a user interface to be displayed during bootup, where the system personality can be set. To use this approach, do the following:. The clone disk also contains a copy of the DRD registry.

Since the source disk that was cloned will not be present when the new virtual machine is booted, there will be no confusion if the DRD registry is removed from the clone:. Once the boot disk has been populated, it can be removed from the original virtual machine and used as the boot disk for a new virtual machine. Then, enter the next commands on the VM host:. Use hpvmstatus on the VM host to determine the hardware address of the clone disk.

You will need it in step 3. Use hpvmmodify command on the VM host to delete the clone from the initial virtual machine:. Use hpvmcreate on the VM host to create the new VM, specifying the clone target as a disk resource.

It is critical that the hardware address of the disk on the new VM be the same as it was on the initial VM:. Jump to: navigation , search. Contacting target "cloud" DRD B. EFI Boot Manager ver 1. Use Enter to select an option. Confidential computer software. All forum topics Previous Topic Next Topic.

Exalted Contributor. Shalom, This depends on your version of hpvm. Trusted Contributor. Yes, you need to restart the guest after changing no. If you modify no. Shalom, 4. Make sure you have the patches. If you go to 4.

Acclaimed Contributor. From 4.